Lumonics Laserdyne 890 2000 Watt Laser

Lumonics Laserdyne 890, 2000 Watt Laser.  This is a 5 axis CO2 cutting laser with teach pendant progamming and off-line programming.

 

Manufacturing in 1998, this laser is capable of leaser etching, laser cuts in 3D and 2D, along with the optoin to cut with Oxygen or Nitrogen laser gas.  More specs provided below.

 

QUOTE REQUEST FORM BELOW 

SPECS:

• Axis travel: X= 96” x Y= 72” x Z= 39”

• C ±450° degrees C axis

• D ±135° degrees

• 7.5” focal length for tight radius laser cutting

• Automatic Focus Control (AFC)

• Breakaway head for nozzle collisions

• 2200-Watt PRC laser Generator

• In-line air dryer

• Dust collector and duct work

• SMC chiller

• Cut with Oxygen or Nitrogen Laser gas

• System 94 controller

• Teach Pendant for programming without models

• Off-line FG cam programming software

• G and M code program codes

• Modular laser fixture table

• Cut materials from .048” to .250”

• Manufactured in 1998

• Required floor space: 160.25” x 125.63”

• Easy access to load/unload parts

• Capable of laser etching

• Laser cut 3D and 2D

• Work envelope of: 8ft x 6ft x 3.25ft

• The moving bridge design of the 890 Beam-Director® provides flexibility for large parts or multiple setups of smaller parts

• The ability to tilt the nozzle 45° above horizontal (±135° tilt travel) gives access to difficult to reach surfaces

• System 94W Laser

Your form message has been successfully sent.

You have entered the following data:

Quote Request for Used Lumonics Laserdyne 890 Laser

Please correct your input in the following fields:
Error while sending the form. Please try again later.

Note: Fields marked with * are required

Please be aware that the contents of this form are not encrypted
Print Print | Sitemap
© Preferred Solutions, LLC 2013